One or More of the cameras returned by the server broker...

[e-slice]

... Could not be connected to. Ibam running 2 USB cams from the same computer and it has worked up until recently when it started becoming hit and miss. The iCam source is still on and working because I get push notifications with the motion detector even when I cannot connect to the cameras.

Any ideas?

[Jay]

The Source Connection error message indicates that both iCam and the iCamSource are able to connect to the iCam Broker Server, but they are unable to connect to each other.

Please refer to this support forum post for further Source Connection Error troubleshooting information: http://skjm.com/forum/index.php?topic=403.0

[e-slice]

Thanks Jay - -

I read all of that and it works fine over WiFi, Edge, and 3g, and if I restart the iCam source it also works but sometimes stops - - and usually when I am away from that location.

Earlier I saw a post about iCam source quitting every 24 hours or so so I will go back and read that (I did not read it earlier because the motion detection was still on)

[Jay]

If you are still seeing the Source Connection error, please email your computer's external IP address to support@skjm.com.

To get it, go to http://whatismyip.com in your computer's web browser and send the IP address it gives you to support@skjm.com.  Please refer to this forum thread in your email.