« previous next »
Pages: [1]

Author Topic: Source Connection Error  (Read 2357 times)

GJR

  • Newbie
  • *
  • Posts: 11
    • View Profile
Source Connection Error
« on: August 07, 2009, 07:11:09 AM »
iCam runs for up to a few hours at a time and then I receive the source connection error. I am using v1.3.2 with port forwarding. To get iCam running again, I stop the iCam source and start it again but if I am away and can't access the computer, this makes reconnecting impossible. Is there anything I can do to stabilise the connection?
Logged

Jay

  • Administrator
  • Hero Member
  • *****
  • Posts: 1096
    • View Profile
Re: Source Connection Error
« Reply #1 on: August 07, 2009, 01:49:27 PM »
That's pretty strange.  Usually Source Connection errors show up right away, not after a few hours.

Please go to http://whatismyipaddress.com/ from your computer running the iCamSource and get your computer's external IP address.  Please email the IP address to support@skjm.com, then I can attempt to look it up in the Broker Server logs and further troubleshoot the problem.
Logged
Pages: [1]
« previous next »