worked yesterday, but now " iCam Broker Server could not be connected to."

[bereabuck]

I've followed your troubleshooting guide for icam. All worked fine yesterday (just after installing it and using it for the first time), but today i get a source connection error... "one or more of the iCamsources returned by the iCam Broker Server could not be connected to." I cannot connect via 3G or WiFi.

My logins match and my firewall (OSX) is allowing incoming connections to icam.

In icamsources preferences it's indicated that UPNP may not be enabled, but it is enabled on my Linksys Wrt54G router. It's the only router I'm using. I haven't troubleshot port forwarding yet and am contacting support first.

I appreciate any help you can provide.

I sent an email to support yesterday with my IP.

[SKJM Support]

Bereabuck is receiving support through email.

[imanos]

Have the same exact issue.
What can I do??

[SKJM Support]

Have the same exact issue.
What can I do??

Are you seeing the "UPNP may not be enabled" status message when the Auto-Config Router option is enabled, and you've check your router settings to make sure that it is enabled?