Cannot launch more than (1) iCamSource in system tray... PC Win7 Ultimate 32bit

[jvt]

Hello,

When I double click the iCamSource icon I can only start one device which show in system tray and is working properly.

When I go to add (double click) the next device the iCam setup icon does not appear in the system tray to setup.

I have run multiple devices 4+ (network, usb, capture cards) with the iCam software with past systems with no problems.

I have tried versions 2.13, 2.15 and have uninstalled and reinstalled the C++2008 libraries. I also did a complete Windows7 OS re-install with the same results.

I have run iCam on the same Intel Atom 510MO motherboard using XP SP3 with no problems.

It has been very puzzling...

System:
Windows7 32 bit Ultimate with latest updates
Intel Atom 510MO motherboard with latest bios/firmware updates
2Gb ram
iCam Software 2.13 and 2.15
Microsoft C++ 9.0.21022.218

Thanks for any suggestions...

jt

[Jay]

New versions of iCamSource (after 2.0) support multiple cameras, so you don't need to run multiple instances of iCamSources anymore.  In fact, you can't run multiple instances anymore.

To add a camera in iCamSource, click the small "+" button underneath the Cameras list on the left side of the iCamSource window.  Then you can configure the settings for the new camera.

[jvt]

Jay,

What an oversight on my part...
After adding my devices, new version works just as you described in the previous post...
Great program and support!

Thanks!!!