Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - e-slice

Pages: [1]

iCam Support / Re: Possible AT&T 3G Changes Coming for iOS Devices Running iCam?

« on: June 14, 2011, 09:57:01 AM »

I think I just posted in the wrong thread -

I am in Aliso Viejo, CA - getting a 198.x.x.x IP from ATT.

I am running iCamSource 2.3, on Win XP Pro. AutoConfig checked and says connected to server.

Cameras set up in my classroom, and I have no access to the routers. Am I just out of luck, or are you working on a fix to the new 3g system?

(iPhone 3Gs jailbroken, RedSn0w 4.3.3 - Using 3G unrestrictor, still no dice)

iCam Support / Re: One or More of the cameras returned by the server broker...

« on: September 28, 2009, 08:56:14 AM »

Thanks Jay - -

I read all of that and it works fine over WiFi, Edge, and 3g, and if I restart the iCam source it also works but sometimes stops - - and usually when I am away from that location.

Earlier I saw a post about iCam source quitting every 24 hours or so so I will go back and read that (I did not read it earlier because the motion detection was still on)

iCam Support / One or More of the cameras returned by the server broker...

« on: September 27, 2009, 09:05:47 PM »

... Could not be connected to. Ibam running 2 USB cams from the same computer and it has worked up until recently when it started becoming hit and miss. The iCam source is still on and working because I get push notifications with the motion detector even when I cannot connect to the cameras.

Any ideas?

iCam Support / Re: Error:n <!DOCTYPE HTML PUBLIC "-//W3C//DTD HTML 4.0 Transitional//EN">

« on: July 17, 2009, 04:20:11 PM »

Thanks -

I guess i assumed MPEG and MPEG-4 were the same - - oh well.

iCam Support / Error:n <!DOCTYPE HTML PUBLIC "-//W3C//DTD HTML 4.0 Transitional//EN">

« on: July 17, 2009, 12:53:09 PM »

I have had iCam working on multiple computers with multiople cameras and mics for a while. All is still working with those but I just set up an IP camera. After rearranging my router to use WEP instead of WPA and finally gettting the camera to work wirelessly through the Linksys HTML interface I cannot get it to work with iCam source. The IP address is http://192.168.1.107 and I tried it by itself, with the /img/video.mjpeg on the end etc. but nothing. With the URL by itself I get the error: Error:n <!DOCTYPE HTML PUBLIC "-//W3C//DTD HTML 4.0 Transitional//EN"> with the /img/video.mjpeg on the end I get HTTP/1.1 500 Internal Error.

It is a linksys WVC11B and it works (old POS from eBay but bought it just to try with iCam) with their html interface...

Any suggestions? Love the iCam app and would like it to work. (also love the push notifications on motion sensing idea, any idea when that will be available? When I click on the button from the info page it still says cannot connect to iTunes or something similar)

Thank you -