Messages

1

ipCam Support / Re: Focus and frame rate

« on: February 14, 2022, 02:03:36 PM »

I never got a reply but it doesn't matter anymore. I found out that webcam+ just suit my needs with live stream, permanent flash and on top on that a separate application in MacOS.

2

ipCam Support / Re: Flash time limit

« on: October 26, 2021, 11:12:12 AM »

Thanks for you reply.

It's intermittent. Sometime it never turns off and the flash stays on, but that's very rare. Mostly it happen within a minute or two. Tried three different iphones (5, 6S and 6S pluS) and same thing is happening over and over again.

3

ipCam Support / Re: Flash time limit

« on: October 08, 2021, 11:37:11 AM »

I've now observed that the flash is turning off intermittent. Sometimes after 5-10 seconds and sometimes after a minute. Then I have to  disable/enable the flash again via the webpage.

Any solution on this matter?

4

ipCam Support / Focus and frame rate

« on: October 06, 2021, 07:00:13 AM »

Is there any possibility to raise the frame rate in ipCam for iphone? As I understand, maximum is 15fps, but I would like to get higher because of stuttering video. 30fps would be great to have for a smooth view.

Also, is there a way to turn off auto focus? The reason for asking is that I'm using an iPhone to check my 3D printer and it's mounted on the printer to be able to view the correct angle of the nozzle. When the printer head is moving around the iPhone tries to focus all the time which makes it more blurry than sharp picture as it's sometime rapid moves.

In the iPhone photo settings it's possible to turn it off by pressing the focus point and hold it for a few seconds, but not in ipCam as far as I know?

5

ipCam Support / Flash time limit

« on: October 06, 2021, 06:53:31 AM »

Is there a way to extend the time the Flash on the iPhone is turned on? As it is now it seems to limit to 30-60 seconds and then turn off. Then I have to click on "turn off" on the webpage to able to "turn on" again.

I have the iPhone connected to an iMac therefore the battery is no problem for me and I would be able to turn on and shut off the Flash manually or be able to set a time limit by myself.

6

iCam Support / Flash time limit

« on: August 26, 2021, 12:02:08 PM »

Is there a way to extend the time the Flash on the iPhone is turned on? As it is now it seems to limit to 30 seconds and then turn off. I have the iPhone connected to an iMac therefore the battery is no problem for me and I would be able to turn on and shut off the Flash manually or be able to set a time limit by myself, lets say 2 minutes or whatever.

7

iCam Support / Frame rate and focus

« on: August 26, 2021, 11:11:50 AM »

Hi there,
As we're in to 2021 and higher band width, is there any possibility to raise the frame rate? As I understand maximum is 15fps but I would like to get higher because of stuttering video. 30fps would be great to have.

Also, is there a way to turn off auto focus. The reason for asking is that I'm using an iPhone to check my 3D printer and it's mounted on the printer to be able to view the correct angle of the nozzle. When it's moving around the iPhone tries to focus which makes it more blurry than sharp picture.