Messages

1

iCam Pro Support / Re: iCamSource Pro 1.3.4 BETA Released with H.264/MPEG-4 Support

« on: February 05, 2019, 03:01:58 PM »

Hi Stefan

I have put aside the other camera with the UDP RTSP feed (!), and gone with the forum recommendation of Amcrest cameras, namely an IP2M-841W and an IPM-721S. I was hoping the PTZ would work from the iOS app but it doesn't seem to work for me. I'm getting video and audio ok on 1.3.4.7 - is there anything specifically I need to do to get PTZ working for the Amcrests?

Regards

D.

2

iCam Pro Support / Re: iCamSource Pro 1.3.4 BETA Released with H.264/MPEG-4 Support

« on: January 13, 2019, 09:31:56 AM »

Thanks for the reply Stefan. I am not trying to change the camera to TCP, I am trying to find out if there is a way to make iCamSource Pro see the RTSP over UDP feed, either by configuration in iCamSource Pro, or via the URL to be used?

The error:

openInputStreamWithURL ERROR - "Invalid data found when processing input" (-1094995529)

... suggests that it may be seeing something, but I wanted to check with the expert 

Regards

D.

3

iCam Pro Support / Re: iCamSource Pro 1.3.4 BETA Released with H.264/MPEG-4 Support

« on: January 08, 2019, 03:49:43 PM »

To add detail I have attempted to add just as RTSP://user:pwd@xx.xx.xx.xx:554/onvif1, and using this in VLC brings up the video stream ok. In iCamSource Pro however, the error is:

openInputStreamWithURL ERROR - "Invalid data found when processing input" (-1094995529)

According to VLC the codec is H264 - MPEG-4 AVC (part 10) @ 1280 x 720. There is an attached audio stream, Mono PCM ALAW @8000Hz, 16 bits.

Hope some of this info helps determine the problem.

4

iCam Pro Support / Re: iCamSource Pro 1.3.4 BETA Released with H.264/MPEG-4 Support

« on: January 07, 2019, 03:52:27 PM »

Hi SKJM

Please can you tell me if there is a way to configure IP cameras which use RTSP over UDP rather than TCP?

Regards

TB