Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - ndt98

Pages: [1]
1
iCam Support / Re: Troubleshooting 102 - Source Connection Error
« on: March 16, 2011, 08:48:06 AM »
Hello,
I have no problem using icam with the wifi connection (at home), but when i use the 3G connection, sometimes it works, sometimes it doesn't ("Source connection error").
At home on the icamsource preferences panel , the url given is "192.68.0.27:8080 ..." , this is an "internal" address.
Outdoor, with my iphone, I access my camera directly  on safari with my ip address (81.56.21.xx:8080) , and it works perfectly.

On the router i see that :
UPNP is not activated
Proxy Wake on Line not activated
Answer to ping not activated

Thank you for your support

2
You can also try probing your camera with all of the known MJPEG and JPEG URLs in our database using this link: http://skjm.com/icam/mjpeg_test.php

Thank you for all your replies, the probing link saved me ! (for those who may have the same problem, you must close the probing link otherwise you won't see the camera  displayed on icamsource)

3
Hello,

I have a Heden Wifi Camera that i correctly installed and it is reachable with the URL http://a.b.c.d/8080 from "outside" or http://192.168.0.27:8080 when i am at home
I try to configure it on icamsource , but i get the message  HTTP/1.0 403 Forbidden when i use the address http://a.b.c.d/8080
and the message "Your network IP camera cannot be connected to. Please check the URL ..."
I don't know what i URL i should use , because Henden camera is not is the list of the camera in "http://skjm.com/icam/mjpeg.php"

Thank you for your help

Pages: [1]