I am getting the dreaded "Source connection error" when trying to access my camera from outside of my network. It was working but now I can only connect when using wifi on my own network.
Here are the details:
I am running icamsource 2.2.1 on a vista sp2 32bit laptop. I am using a Logitech 9000 camera connected to usb port on the pc - not using a hub. I have shut off Windows firewall. I have shut off my Belkin 23834a router firewall. I have put the ip of my pc in a DMZ on the router. I have tried "Auto-config router" but I get this: Error:UPnP 2. NAT-PMP 3.-5.0
I checked the router and UPnP is enabled.
I did port forwarding for ports 12000-12005. portchecker shows these ports are open.
I changed icamsource to only use ports 12000-12005.
I have run out of ideas. Any thing else I can try?
