Messages

1

iCam Support / Re: After reboot, iCamsource won't run

« on: September 23, 2010, 01:14:36 PM »

I've seen issues still.  But when I get the error now, I just uninstall it and reinstall it and add the cameras and it works fine for a while.  Something is making it not work.  Right now, I am testing it WITHOUT a wireless camera to see if that is what is making it stop working.  So for now, I only have 2 USB cameras running. 

2

iCam Support / Re: password problem with icam source 2.1.1

« on: September 15, 2010, 11:32:37 PM »

I used to use icam source 1.4.2.5. It worked perfectly. This morning  I updated icam source to 2.1.1 version. Whenever I log in, my iphone says 'no source found'! The weirdest part is that if I creates a 2 letters long password, it works!! If I creates a more than 2 letters long password, it doesn't work. 2.1.1 version has a problem with password.

Had the same problem.  Changed my password to two letters (as well as username) and it worked.  Went back and STOP the cams, changed all the passwords back to 8 letters and then changed it back on the iPhone and it worked fine using 8 letters for the password.

3

iCam Support / Re: After reboot, iCamsource won't run

« on: September 15, 2010, 11:23:21 PM »

OK - I was having the same problem.  At first, 2.1.1 was running fine.  Then all of a sudden (maybe after a reboot, I dont remember) iCamSource would just instantly pop up an error and not load up.  I uninstalled, rebooted, reinstalled about 10 times with various combintations.  So then I uninstalled, rebooted and then went and looked at the registery.  There were traces of iCamSource in:
HKEY_CURRENT_USER\Software\SKJM, LLC\iCam

I deleted that, rebooted and then reinstalled 2.1.1 and BAM!  It works again!  Lets hope it keeps working!