Messages

1

iCam Support / Re: one usb, one wireless, both show on icamsource. only one shows on iphone icam

« on: June 06, 2011, 09:08:56 PM »

I'm not getting any error message. There are three cameras configured. One on the iMac and two wireless Linksys cameras. If I pull up iCamsource on the iMac I can go through each camera and see its associated video. However, if I bring the app up on my iPhone the app loads fine but only displays the video feeds from the two Linksys cameras, it does not display the iMac's iSight video.

Funny... I am having the opposite problem. I have two wireless Cisco WVC80N cameras and one USB camera hooked to a Mac Mini. The wireless cameras will sometimes not show on iCam. No error message, just a no-show. The USB camera always loads.  And, all ameras always load on iCamweb. If I stop and start the feed in iCamsource, the wireless cameras show for a bit, then disappear again.