Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - nyvin

Pages: [1]
1
iCam Support / Re: when run as a scheduled task, iCam source just says connecting
« on: November 14, 2010, 05:28:27 PM »
Tried manual port forwarding, tried the UPNP Auto Port Config, tried uninstalling and removing all the registry component, reinstalled and exactly the same thing happens.

Anyone else successfully running the iCamSource as a scheduled task?

2
iCam Support / when run as a scheduled task, iCam source just says connecting
« on: November 10, 2010, 04:40:13 PM »
I then click Stop, then start and it works - I need it to work via the scheduled task.

Has always worked in the past, problems started with 2.1.4 of the iCam Source.

Tried the port forwarding stuff, that made no difference at all.

Any ideas?

PC is Windows 7 x64.

Pages: [1]