Messages

1

iCam Support / Re: Icam uses 80-90% CPU

« on: October 18, 2010, 07:07:48 AM »

These were readings without motion detection enabled.  That's probably my case.  Old computer.  Thanks for all your assistance.

2

iCam Support / Re: Icam uses 80-90% CPU

« on: October 17, 2010, 08:23:53 AM »

Using just the USB cam the CPU usage is 30%.  If I add one IP cam it jumps to 50%.  All IP cam framerates settings are set to 5 in the MJPEG section.  I'm using a local IP address that is in the router settings.

3

iCam Support / Re: Icam uses 80-90% CPU

« on: October 16, 2010, 08:03:17 AM »

Yes.  With no cams CPU is 1 to 4%, with 1 Linksys IP cam CPU is 20%, increases 20% with each additional cam.  Is this normal?
Also, I use TZO Dynamic DNS with my Wireless-N IP cams.

4

iCam Support / Re: Icam uses 80-90% CPU

« on: October 15, 2010, 08:22:10 AM »

 I'm having the same issues.  I'm running version 2.14 on a Dell 2.66 dual core processor with Windows 32 bit Vista Ultimate, I have 3 linksys wvc80n wireless cams and 1 microsoft usb cam.  I set all the fps settings on the IP cams to 6, still using 80-90% cpu.