Messages

1

iCam Pro Support / Webpage sources not found with Pro

« on: July 01, 2014, 08:49:34 AM »

Used to work fine with old version, but just shows no sources found.

Works on my iPhone/iPad with proxy support enabled (which btw did not have to use in previous version)

2

iCam Support / Re: Supported Pan-Tilt USB Webcams and Network IP Cameras

« on: February 27, 2012, 11:24:21 AM »

I have a Foscam FI8908W Wireless IP Camera and the pan/tilt operation is slow (to say the least), is their anything I can do to improve the speed of the movement ?

3

iCam Support / Re: Duplicate Cameras (iPhone 4.01 / Mac OS 10.6 / iCam Source 2.1 / iCam 2.0)

« on: September 17, 2010, 01:34:02 PM »

I had similar issue, I was showing one of my 5 cams twice. But I found, closing and restarting iCamsource cured it.

4

Beta Testing / Re: iCamSource 2.0 BETA

« on: September 15, 2010, 02:04:39 PM »

Not working now I am on running icamsource 2.1, with Auto-Config Router checked, it errors with UPnp 3: NAT-PMP 5,53,48,1

With or without that enabled it don't work at all from icam software on iPhone,

I currently have 3 cameras connected

HELP!

5

Beta Testing / Re: iCamSource 2.0 BETA

« on: August 19, 2010, 08:51:17 AM »

I dont have the beta for v2 for my iPhone yet, but I installed the iCamsource Beta 2 and from my iPhone or via the Webpage, I am unable to view the cameras, broker error, ports are set the same as before.

UPDATE:

I can now see one of my camera's via iCam or the iCamweb page and the iMac camera does not show up at all, even in the icamsource application on the mac. The other 4 cams give the broker error. I have the exact login info as all the others, but only 1 shows.

UPDATE 2: Now I restarted iCamSource and I see 3 out of the 5 cam's (still no iSight camera)

Refreshed iCam on the iphone again, now only one cam showing!

I found that if I don't have the iSight added to the list of cameras and if I have auto config router enabled, it all works!

Restarted iCamSource and now see 2 cams (not iSight)