Messages

1

iCam Support / Re: Trying to connect using 2 of the same model webcams

« on: April 28, 2010, 01:43:01 PM »

Turning off audio doesn't help either! 

2

iCam Support / Re: Trying to connect using 2 of the same model webcams

« on: April 27, 2010, 06:48:46 PM »

The only thing I have not tried yet is turning off audio, which will I will try tomorrow when I get home!

3

iCam Support / Re: Trying to connect using 2 of the same model webcams

« on: April 27, 2010, 06:39:39 PM »

Yes it shows the exact web cam listed twice, if I choose the first one and start it runs fine, then open a second icam source and choose the second webcam and try running I get the error, even if I try choosing the first one on the second window I get the error as well. If I close the second icam source and choose the second webcam runs fine. In the webcam software that came with the webcams it shows both webcams but one has a _1 behind it, it doesn't show that anywhere else thou. I tried running one webcam through manycam under icam source which works and when I try and open a second icam source and run the other webcam get same error code as well.

4

iCam Support / Trying to connect using 2 of the same model webcams

« on: April 26, 2010, 11:59:02 PM »

I'm trying to run both of my webcams, they are both the same model number, under Windows Vista. I can get each one to run separtely in one window but when I try running them both in two windows I get a error 14 message. I'm pretty sure it's because the are both the same model number and show up exactly the same to windows, is there a way I can get around this?