Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - noodleNT

Pages: [1]
1
iCam Support / What ports are used?
« on: December 28, 2009, 12:36:34 AM »
I have a few other applications running on the same computer that I want to us iCam on. I think I am getting a conflict because once I start iCam I have to hard reboot the machine to stop it. The stop button just causes it to lock up and taskkill will not end the icam process.

Pages: [1]