Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - derk001

Pages: [1]
1
The image captured from your webcam is resized to fit on the iPhone screen before it's sent to iCam.  The 640x480 image is already being resized smaller, so using a larger input resolution would just increase the amount of image processing without gaining any image quality.  The preview screen in iCamSource is currently fixed size.  It's meant to show a preview of the image size that will be displayed on the iPhone.

Since your camera is a USB camera, it doesn't need an MJPEG URL.  The MJPEG URL is for network cameras.

For a USB camera, you'll need to select the "USB / Built-In / Firewire"  tab in iCamSource and select your webcam from the Video drop down list.


The iCamSource acts as a server right? It is possible to use the CamWeb interface, but if I would like to build my own page, can I just dip in the source of CamWeb? It's the URL to the USB cam I need. ;-)

2
Setting: I have two Linksys WVC54GCA camera's and a Logitech Quickcam Pro for Notebooks USB camera and I run Mac OSX Snow Leopard 10.6.2

1:I know my Linksys don't support anything over 640x480 BUT, the Quickcam should be able to support 1280x1024. How can I use that resolution in iCam or iCamSource? Logitech doesn't have software for OSX, so I can't look there.

2: How can i get the URL for my USB camera? How do I need to address iCamSource?

3: The tiny preview of iCamSource, how can I get it bigger? I'd like to be able to view my cams on the big screen. :-)


Any help is appreciated!  :)

3
Network / IP Camera Compatibility / Re: Best Wireless Cam for Mac?
« on: December 13, 2009, 08:56:53 AM »
About the Linksys WVC54GCA; motion capured images aren't sharp, you can't hang the thing outdoor, and at night it just gives you a black image, unless there is a streetlight of some kind.

It's acceptable, but not good.

Pages: [1]