Messages

1

iCam Support / Re: Troubleshooting 103 - Port Forwarding

« on: December 20, 2020, 09:02:53 PM »

To use port forwarding, you will need to both enable port forwarding in the iCamSource and setup a port forwarding range in your router.
If you are running Windows, you will need to set an iCamSource registry key:
1. Download the following REG file to your computer. 
2. Restart the iCamSource. You should now see a checkbox allowing you to enable Port Forwarding. Check it, and you should see the range 12000 to 12100 by default.

Trouble out of the gate getting port forwarding to work.

I download the reg file and merged it into the registry.
I stopped and restarted the iCamSource program but still I see no "Port Forwarding checkbox" under any tab in the iCam interface.

I also have "Notifications" checked, but I didn't see anywhere to enter an email or TXT number to send notifications to.

Thanks!