Messages

1

iCam Support / Re: Hangs up on stop command

« on: February 23, 2009, 10:07:37 AM »

I've been trying some other configuations and found that audio was the problem.  I'm not using audio so I hadn't tried any other.  When I did it allows me to stop and close without hanging up. Now it works fine.  The default was "USB AUDIO INTERFACE" which was the cause.  I have 5 different audios to chose from.  All the others allow the program to close normally.  Possibly the "USB AUDIO INTERFACE" driver is not installed properly.
Now it's working the way I want, with 4 different video sources on 4 ICAM Sources and viewable on my IPOD Touch.  This is great!
The ICAM/WEB  site is also a nice addition to the system.
Thanks.    Jerry

2

iCam Support / Re: Hangs up on stop command

« on: February 23, 2009, 07:32:02 AM »

Good Morning.  Also hangs when stopped by "X-ing" out while running.  The task manager shows 2 ICAM's "not responding" even though only one was opened and will not shut it down either.

3

iCam Support / Hangs up on stop command

« on: February 22, 2009, 05:36:00 PM »

ICAM is one of the coolest apps.  It worked fine,even with multiple cameras, but since downloading 1.1.1 I can open ICAM source and it works.  The problem is when I click on the stop button, It stops and hangs up and am unable to close it.  I can't even end it with the device manager or shut down the computer without pulling the power cord.   I'm running XP sp3.
Any Ideas?
Jerry