Messages

1

iCam Pro Support / Re: For the past 2 nights icamsourceprocrashlog has generated 16 gb of logs

« on: February 25, 2016, 09:18:16 AM »

deleted as it put my windows partition at 0kb, will check logs if it happens again

2

iCam Pro Support / For the past 2 nights icamsourceprocrashlog has generated 16 gb of logs

« on: February 25, 2016, 09:15:59 AM »

For the past 2 nights icamsourceprocrashlog has generated 16 gb of logs, this just started happening any ideas?

3

iCam Pro Support / Re: Will the iCamPro FHD be supported?

« on: April 04, 2015, 04:44:00 PM »

Thank you for the information! I will be sure to test this and report back in a couple months.

A

4

iCam Pro Support / Will the iCamPro FHD be supported?

« on: March 14, 2015, 12:21:28 PM »

Just went on the wait list for them to be shipped in June, will iCam Pro support this at launch?

A

5

iCam Pro Support / iCamSourcePro.exe has stopped working

« on: March 12, 2015, 12:24:17 AM »

Hello,

Just purchased and installed iCamSourcePro.exe on a fresh windows 7 setup. As the title states, I get this crash error almost every 2-3 hours using a Logitech Orbit Cam AF hooked up to a 32 ft. USB cable if that matters.

Everything was working fine for the past week until 2 days ago. When I also stop the camera I get this Unhandled Exception error consistently:

justpaste.it/jwby
Any ideas? Would you need more information? Thanks in advance.

//EDIT
After uninstalling and removing every reference to icam using regedit and doing a fresh install, all seems to be working well for now

A