Messages

1

iCam Support / Re: Cant get video after switching to android.

« on: July 08, 2014, 08:44:02 PM »

Ok i now eliminated my router. Making sure upnp was enabled, it said it was successful with auto config, but i still cant see the webcam. I also made sure windows fire wall had icam in it as an exception, i dont know what else to do.

2

iCam Support / Re: Cant get video after switching to android.

« on: July 08, 2014, 07:12:58 PM »

192.168.1.6 I used IP config to make sure the .6 was my computer. I also tried to port trigger so I wouldnt have to assign an IP address to the device but that had no luck either

3

iCam Support / Re: Cant get video after switching to android.

« on: July 08, 2014, 07:12:21 PM »

heres another incase thats hard to see

4

iCam Support / Re: Cant get video after switching to android.

« on: July 08, 2014, 07:11:22 PM »

It said it was blocked but here is my screen shot

5

iCam Support / Cant get video after switching to android.

« on: July 08, 2014, 12:32:45 PM »

I had this program for quite some time on my iphone 4/5 with verizon. So I bought it again when I recently switched to a galaxy s5 on t mobiles network and I am no longer able to use this over 4gLTE only wifi. I went to the help section and read about making sure the android thing is check marked, did that. It still didnt work. I also read instructions about downloading the registry key and trying to configure my router. My router has upnp enabled for the auto config but still did nothing with it enabled on both the program and router.  Then I  triggered the ports manually and set manually configure in the program to  12000-12005 (still unsure if i did that right) cause I only put one line and set the range 12000-12005, not sure if that needs more. But I am able to get motion detection alerts now that ive made some changes! But can you please help me out, I love this program and dont want to use anything else!