1
iCam Support / Re: Easyn Camera not working with ipcam
« on: October 01, 2013, 05:10:19 PM »
ok ignore my post I figured it out, I was not using the http:// is the problem. I added it and it works fine now.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
1
iCam Support / Re: Easyn Camera not working with ipcam« on: October 01, 2013, 05:10:19 PM »
ok ignore my post I figured it out, I was not using the http:// is the problem. I added it and it works fine now.
2
iCam Support / Easyn Camera not working with ipcam« on: October 01, 2013, 05:09:25 PM »
I have an easyN F series ip camera. I am using the address xxx.xxx.xxx.xxx:xx/video.cgi
When I place that exact address into a web browser it works fine but when I use it in the icam client software it always gives me the error "your network camera could not be connected to....." I have the correct user and password and have tried using mjpeg and jpeg. I have also tried several other variations of my url like without the video.cgi and some others for other cams. I have advanced networking configuration knowledge and I can use my cam on my network and view it just fine on the web with my dyndns address as well but it never is seen by the icam source software. I have the icam source software on 4 different computers at my house and I tried to use the ip cam on three different ones with no luck. My usb cameras work just fine and I have tried the ip cam on computers with and without the usb cams. Anyone have any suggestions I can try that I havent mentioned???
Pages: [1]
|