Messages

1

iCam Support / Re: Almost connected!

« on: September 12, 2013, 10:01:13 PM »

Enabled manual port fwd outcome s still the same. I think iwillnstart reinstalling adapters at this point as I feel,its isolated to the machine and not the router.worked fie on a 3rd computer as well.

2

iCam Support / Re: Almost connected!

« on: September 11, 2013, 09:33:24 PM »

Ok, so my son had a older version 2.2.3 on his mac still and it works, I set him up exactly like my macbook thats running 2.7.1 His works just fine. I went through Mac firewall settings and both are disabled. I will try to move his 2.2.3 over tomorrow evening and see if that solves anything.

3

iCam Support / Re: Almost connected!

« on: September 11, 2013, 08:38:13 PM »

Forgot to add, I can't connect via wifi on same network either

4

iCam Support / Re: Almost connected!

« on: September 11, 2013, 08:36:45 PM »

Yeah, I have all the nat turned off in the AT&T modem/router and everything is fwd to the airport. I have OTHER devices forwarded and the function fine.

I get all the push notifications it just won't connect to video. If I disable the port forwarding the pushes stop. I have tried on multiple iOS devices also.

5

iCam Support / Re: Almost connected!

« on: September 10, 2013, 08:33:46 PM »

DHCP is not running on the APL EXTREME. Every thing is setup as static and mac address routing. I can seem to route everything but iCam. It seems to communicating as it is accurate in sending push notifications to the devices

6

iCam Support / Almost connected!

« on: September 09, 2013, 05:07:40 PM »

Get Source connection error (returned by broker server). I get push notifications but when I tried to view the camera it wont connect. I FWD all the ports, autoconfig returns Double NAT, I am running a at&t uverse NVG510 manualy bridged to a Airport extreme. Any suggestions? everything else I have forwarded work fine!