Show Posts
1
iCam Support / iCamSource Port Forwarding
« on: July 15, 2013, 10:38:08 PM »
Hi,
My iCamSource isn't working. On the app it says "UPnP May Not Be Enabled." I went into my router settings and enabled UPnP and it didn't work after that either. I then followed the steps in another forum post on port forwarding but my router wasn't listed on the website that was in the steps. I then tried to forward a port in my router settings and typed in:
Service Port: 12000-12100
IP Address: (my computer's ip address)
Protocol: ALL
Status: Enabled
I clicked save and got this message: "The IP address is not in the same subnet with the LAN!"
I'm new to port forwarding so any help would be greatly appreciated. If it says "UPnP May Not Be Enabled" on the iCamSource, then that's probably why the iCamSource isn't working right? Any help would be greatly appreciated.
Etc.
Thanks
My iCamSource isn't working. On the app it says "UPnP May Not Be Enabled." I went into my router settings and enabled UPnP and it didn't work after that either. I then followed the steps in another forum post on port forwarding but my router wasn't listed on the website that was in the steps. I then tried to forward a port in my router settings and typed in:
Service Port: 12000-12100
IP Address: (my computer's ip address)
Protocol: ALL
Status: Enabled
I clicked save and got this message: "The IP address is not in the same subnet with the LAN!"
I'm new to port forwarding so any help would be greatly appreciated. If it says "UPnP May Not Be Enabled" on the iCamSource, then that's probably why the iCamSource isn't working right? Any help would be greatly appreciated.
Etc.
Thanks