Show Posts
1
iCam Support / Motion settings on the camera or on CamSource
« on: June 25, 2013, 10:29:55 PM »
In my Dlink DCS 942, I have the option to enable PIR (Passive Infrared) motion detection. Along with that, I have to choose the area that I want to record. The recording goes on a SD card which I have enabled and the emailing of photos and videos are disabled.
Enabling Motion Detection, should that be done only in CamSource and not on the camera software itself? Can I have both enabled or would that cause more events to appear than necessary?
Enabling Motion Detection, should that be done only in CamSource and not on the camera software itself? Can I have both enabled or would that cause more events to appear than necessary?