Show Posts
1
iCam Support / Re: when run as a scheduled task, iCam source just says connecting
« on: March 06, 2013, 06:20:44 AM »
First off with the WiFi speeds it still works just viewing the cameras is slow via Foscam software on my pc and any connected devices like ipad ect see a speed decrease if icamsource is running they still work but as were they would see 12Mbps they now get around 5Mbps(icamsourcerunning) i will test this more but it was definitely annoying.
I originally had icamsource running via upnp which was enabled in my router (Linksys WRT54GS with DDWRT) and was getting the same problem, i also tried the manual ports with registry checkbox and forwarded the ports in my router.
Now the ports i may have done incorrectly im assuming i need the ports range from 12000-12100 open?
here is screenshot. I have the dedicated pc set with a static ip in my router.
I did however have a batch file to kill icamsource everyday i will have to grab it off the other pc but it looked similar to the one you posted, i also have task to reboot pc daily.
I also noticed that after i started having the problems even starting icamsource from the start menu with autostart it is not connecting until i stop and start it again.
I originally had icamsource running via upnp which was enabled in my router (Linksys WRT54GS with DDWRT) and was getting the same problem, i also tried the manual ports with registry checkbox and forwarded the ports in my router.
Now the ports i may have done incorrectly im assuming i need the ports range from 12000-12100 open?
here is screenshot. I have the dedicated pc set with a static ip in my router.
I did however have a batch file to kill icamsource everyday i will have to grab it off the other pc but it looked similar to the one you posted, i also have task to reboot pc daily.
I also noticed that after i started having the problems even starting icamsource from the start menu with autostart it is not connecting until i stop and start it again.