Messages

1

iCam Support / Re: Bluescreening PC

« on: September 22, 2009, 03:06:16 AM »

I analyzed the memory.dmp. The problem was the Logitech webcam and the file lvckap.sys. Here is a solution:
http://forums.logitech.com/logitech/board/message?board.id=quickcam_software&thread.id=518&view=by_date_ascending&page=2

2

iCam Support / Bluescreening PC

« on: September 18, 2009, 01:52:07 AM »

My PC bluescreens every time i start iCam Source. It's a new install and there is nothing installed on it. I can start iCam but when i start the camera it dumps the memory. The PC is an old one, IBM T41 with 2 gb ram, but it have worked ok so far and i havent seen any system requierments for iCam. It seems like the application uses alot of system resources ( CPU, memory). Someone that have the same problem? Or even better, a solution  . And is there any system requirements for iCam?