Messages

1

iCam Support / Re: Foscam FI8910W does not view in iCamSource

« on: January 13, 2013, 09:28:59 PM »

Setting a iCam login and password was the ticket.  This can not be left blank.  The camera password does not need to be set.  Thank you so much for your help.

Rip

2

iCam Support / Re: Foscam FI8910W does not view in iCamSource

« on: January 13, 2013, 06:36:50 PM »

Pass word settings and user name on the camera have not been changed. 

The address:   http://192.168.1.145:8090 works in firefox to pull up the camera control page.  In this case the page is a Foscam option page listing options for Active X,  Server Push Mode and mobile phone.  I click Server Push Mode and the camera control comes up with the picture. 

The address:  http://192.168.1.145:8090/video.cgi in firefox goes directly to the camera video.

I have tried both addresses in iCamSource with no luck.  Just so I know that I am entering things into iCamSource correctly, here is my procedure:

Under the Camera tab and the WiFi tab, I entered the address.  I checked mjpeg and entered the login which is the camera user name .  There is no password.  There is also no iCam login or password yet.  The "Auto-Config Router" is unchecked and the "AutoStart" is unchecked.  The frame rate is set in the middle.  I then hit start and I am assuming I should get a picture in the preview scene.  The Start button stays gray and I get nothing.  Am I doing this correctly??

 

3

iCam Support / Re: Foscam FI8910W does not view in iCamSource

« on: January 13, 2013, 09:09:49 AM »

Thanks for the response.  The typo was on my message, not the iCamSource.  Here is a copy the of the address used:  http://192.168.1.145:8090/video.cgi

4

iCam Support / Foscam FI8910W does not view in iCamSource

« on: January 12, 2013, 02:33:28 PM »

I am a Newbie trying to set up a Foscam FI8910W. The ultimate goal is to use it with an ipod touch.  The set up is WiFi thru my home Lan.  I got the camera to work with the Foscam viewer but can not get it to view using iCamSource.  The URL that I am using is http//:(foscam url):port/video.cgi.  The forums all say the "video.cgi" extension should work and apparently it does for everyone but me.  Clearly I am doing something wrong but I haven't a clue.  I have tried not using the port number as well as various extension combinations but have not found an answer.  Anybody got any ideas.
Rip