Messages

1

iCam Support / Re: ImogenStudio +Cam

« on: January 12, 2013, 10:37:09 AM »

This is the URL that finally worked for me.
http://admin:admin@XXX.XXX.XXX.XXX/goform/video (where "XXX" is the IP address)

2

iCam Support / Re: ImogenStudio +Cam

« on: January 10, 2013, 02:39:26 PM »

I contacted support from the camera company and was able to get a URL that worked with Icam.  I have it setup and working now.

3

iCam Support / Re: ImogenStudio +Cam

« on: January 02, 2013, 03:32:22 PM »

An update on this I still have not got it to work with Icam.
The Manufacturer is not listed on the page to get the URL so I tried the scanner.  None of the urls listed showed a picture or video.  I have tried many ip addresses but still can't get any url to work for Icam.  I have been working with support to see if there is anything else I can try.

4

iCam Support / Re: ImogenStudio +Cam

« on: December 28, 2012, 05:57:21 PM »

I purchased this camera recently and have been trying to get it to work with icam but haven't had any luck.  I still can't find the url to use because the manufacturer is not listed on the url lookup page.  The camera works fine with the isecurity app that they want you to use.  I will let you know if I get it working.