Messages

1

iCam Support / New IP Cam (Foscam FI8910W)

« on: October 07, 2013, 03:52:12 PM »

First off, I would like to say that I have been using ICam for about a year now and it is awesome, thank you.
Ok I am currently running ICam source on my windows computer and using it's web cam so I can view on my Iphone. Now I have purchased the Foscam FI8910W. I used the Foscam disk to do the initial setup and it runs via WiFi while on the Foscam Software but have been unable to get the ICam source to find it and would like some assistance.
1. Do I need to do port forwarding again for this new camera or will the existing port take care of it?
2. I read that I need to download the ICam source again, it that true?
Of course any suggestions would be greatly appreciated.

Thank you in advance

Robert

2

iCam Support / Re: Troubleshooting 103 - Port Forwarding

« on: December 11, 2012, 07:54:28 PM »

Hello,
I recently began using your ICam program and it works great on WiFi but unfortunetly like many others I am unable to connect over 4G/Edge. I attempted to set my port forwarding and still nothing. I tried the Port checker and it just says "Checking UDP Port : 12000 (please wait 5 seconds for the test to complete)" and thats it, no message ever comes up saying if it is open or not.
I have a Qwest Modem, Actiontec PK5000.

Any help you could provide would be much appreciated.

Thank you in advance for your assistance

Robert