Messages

1

iCam Support / Re: No error message, but no picture

« on: November 23, 2012, 07:33:23 PM »

Got it. One of the alternattive URLs
worked fine. Up and running.  Thanks so much. 

2

iCam Support / Re: No error message, but no picture

« on: November 23, 2012, 12:09:27 PM »

The specs for the vivotek are below - seems to support mjpeg


Compression: MJPEG & MPEG-4
Streaming:
Simultaneous dual streams
MPEG-4 streaming over UDP, TCP, HTTP or HTTPS
MPEG-4 multicast streaming
MJPEG streaming over HTTP or HTTPS
Supports 3GPP mobile surveillance
Frame rates:

MPEG-4: Up to 30/25 fps at 352x240 (NTSC) / 352x288 (PAL)
MJPEG: Up to 30/25 fps at 352x240 (NTSC) / 352x288 (PAL)

URL is http://xxx.xxx.1.2/video.mjpeg



 

3

iCam Support / No error message, but no picture

« on: November 23, 2012, 09:05:50 AM »

Hello,
I am running an analog camera through a vivotek network video server (VS7100). The server is connected to my primary wired Linksys router, and I a, running a Netgear WNDR3400 wireless router off of that network (this is a Vista machine). The wirelss router is set up as a "dummy", with the IP addresses being assigned by the Linksys. I am able to see a picture on the vivotek server from a nardwired compture and also on a another computer via the wireless router, but I cannot see the picture in ICam source. I receive no error messages and the "preferences" screen indicates that I am connected to the server. I have the URL of the vivotek server in the Ethernet tab, but no picture. Any ideas on what the check next? thanks.