Show Posts
1
iCam Support / Help setting up multiple cameras in 10.5
« on: September 22, 2012, 02:38:15 PM »
Hi all. I have iCam running on a g4 Powerbook running 10.5.8. I have two identical cameras (Xbox 360 lifecams). In setup, my cameras are listed as:
"1 Video Camera"
"2 Video Camera #2"
Whichever camera is selected as "1 Video Camera" works fine. "Camera 2 #2" lights up as if it is active but I'm not getting any feed from it occasionally I will get a frozen frame but that's it. It also intermittently powers down and back up again. I have tried each camera one at a time on both my USB ports and they both work fine. As soon as I plug them both in, things go wonky.
Does anyone have any ideas as to what may be going wrong? Could it be that the cameras are conflicting because they're identical?
"1 Video Camera"
"2 Video Camera #2"
Whichever camera is selected as "1 Video Camera" works fine. "Camera 2 #2" lights up as if it is active but I'm not getting any feed from it occasionally I will get a frozen frame but that's it. It also intermittently powers down and back up again. I have tried each camera one at a time on both my USB ports and they both work fine. As soon as I plug them both in, things go wonky.
Does anyone have any ideas as to what may be going wrong? Could it be that the cameras are conflicting because they're identical?