Messages

1

iCam Support / Re: Troubleshooting 102 - Source Connection Error

« on: July 11, 2012, 06:08:21 PM »

I found the solution. I had set the forwarding under the Single Port Forwarding tab. I noticed this when I went to do the screen print and switched to the Port Forwarding Range tab. now all is working. Thank you for the help.

2

iCam Support / Re: Troubleshooting 102 - Source Connection Error

« on: July 11, 2012, 05:27:10 PM »

I ran the port checker and it tells me that the port is blocked. I will take a screen shot of my router config and send it to you. Hopefully you'll be able to pick out what I'm doing wrong.

3

iCam Support / Re: Troubleshooting 102 - Source Connection Error

« on: July 11, 2012, 08:15:25 AM »

Thank you for the quick response. Background on my issue: I am running iCamsource on a Dell XP Laptop. I am running the iCam App on a gen 1 iPad. I have a Cisco / Linksys L1000 wireless router for my network at home.  When I use the same WiFi network it works fine. The problem is when I have iCamsource running on my home WiFi and the App on my iPad running 3G.  I have done the port forwarding as suggested with all permutations of checking and un-checking Auto Config Router / Port Forwading. When I get home this evening I will do what you've suggested and e-mail my Config screen shot. The IP address I put into the router Config for Port Forwarding is my laptop's address, not the public IP address of the router. I know this shouldn't matter, but I just want to be as specific as possible. Thank you again.

4

iCam Support / Re: Troubleshooting 102 - Source Connection Error

« on: July 10, 2012, 04:40:44 PM »

I have read and implemented all of the suggestions on this board to correct the error with no success.  What's next?