Show Posts
1
Network / IP Camera Compatibility / DLINK DCS-932L
« on: June 25, 2012, 05:20:37 AM »
Hey guys,
I apologise in advance if a similar thread has already been started. I just purchased a D-LINK DCS-932L network camera. I run a 13" Macbook. I obtained the camera's IP address and inputted the address into icamsource's URL area on my mac. I have a 2nd camera enabled- my isight camera (built into my macbook). Both show up on my icamsource and work perfectly.
All is well until I installed the iPhone app and tried to view those cameras remotely. My isight camera comes up fine- my D-Link however comes up as a still colour image that does not move.
I mention colour because at the moment the D-LINK camera is set to night mode (black and white) however even the still image appears to be one from my isight camera and not the D-LINK.
Bit lost here...
I apologise in advance if a similar thread has already been started. I just purchased a D-LINK DCS-932L network camera. I run a 13" Macbook. I obtained the camera's IP address and inputted the address into icamsource's URL area on my mac. I have a 2nd camera enabled- my isight camera (built into my macbook). Both show up on my icamsource and work perfectly.
All is well until I installed the iPhone app and tried to view those cameras remotely. My isight camera comes up fine- my D-Link however comes up as a still colour image that does not move.
I mention colour because at the moment the D-LINK camera is set to night mode (black and white) however even the still image appears to be one from my isight camera and not the D-LINK.
Bit lost here...