Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - phunte

Pages: [1]
1
iCam Support / Re: Auto-Start
« on: March 29, 2011, 10:50:41 PM »
I tried following the steps in this post, and I have an "iCam" service. I can start the service, and I see icamsource.exe as a process for a couple of seconds in Task Manager, but then it seems to terminate. Any ideas how I can debug why it terminates?

Thanks, phunte

Pages: [1]