Messages

1

iCam Support / Re: IPCAM support

« on: March 22, 2010, 11:47:13 AM »

Mine does. although with the new firmware it remembers the last position the camera was in, if there was a powercut or reset. Which is nice.

2

iCam Support / Re: IPCAM support

« on: March 17, 2010, 09:40:58 AM »

Hey guys, I have found an invaluable source for updating the unbranded IPCAM.

You guys have probably already done it hence the silence on this thread but if not please go here for all your needs, PC or Mac after updating there was no more need for the stupid activex. Thank god.

http://www.gadgetvictims.com/2009/06/foscam-wireless-pan-tilt-ip-camera.html

and

http://www.gadgetvictims.com/2009/07/foscam-ip-camera-part-two.html

Helped me to no end.

Regards
David

3

iCam Support / Re: IPCAM support

« on: August 13, 2009, 06:33:44 AM »

It appears to be unbranded, first time I've ever done that! Oops. It also appears to be closely related to a company called Foscam. I have requested some further information from the company I bought it from. I have set it up and it works, it has motion detection and emails me whenver something has changed, though it is not as elegant a solution as icamsource. I just wondered if it could work with your software?. I just have no technical knowledge in activex webcam streams and where the hidden stream source could be found to transmit to the icamsource servers. I could give you a link to the webcam if you like?
Regards
David

4

iCam Support / IPCAM support

« on: August 12, 2009, 02:48:09 PM »

Hello, I have just purchased a couple of IP Webcams called IPCAM02, they are pan and Tilt ip webcams.
They have MJPEG image compression and have a 15fps(VGA) and support HTTP,FTP,TCP/IP,UDP,SMTP,DHCP,PPPoE,DDNS,UPnP,GPRS
Initially I had to set them up via a PC to get them to access the airport extreme network, I have also set it up via dyndns.org/ and got it to NAT to my dynamic I address. All good as long as I use internet explorer using activeX. They can also warn me via email alerts.
My main problem - I cannot find the stream link to connect it to icamsource, is this possible?

Regards
David