Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - kswhotdat

Pages: [1]
1
iCam Support / Re: newbee problems
« on: November 10, 2011, 04:57:52 PM »
Ok, I'm not using UDP port 12000s, but ports 8090s. When I installed my foscam camera, that is what they recommended, so I used the 8090s for all the cameras. Also, foscam advised using my internet IP, and not the local IP assigned by the router (for the iphone app). Should I be using the UDP 12000s? Is that what my problem could be?

btw, how did that payday loan ad get in here?

2
iCam Support / newbee problems
« on: November 10, 2011, 09:14:42 AM »
Hello, I installed icamsource on my computer and have had no luck on getting my wireless cameras to connect. I've tried all the URLs listed in the troubleshooting sections and don't know what to do next. I have the following equipment:

Uverse Gateway/Router i38GH

4 D-link 930L wireless cameras
1 FoScam FI8918W wireless camera

I have the Dlink & Foscam software on my computer and they both work with the cameras. I also have the iPhone apps for Dlink and Foscam they also work correctly. I thought it would be nice to have all the cameras in one app. I haven't downloaded the iphone app yet as I want to make sure I have the icamsource working first. 

After trying to connect the first few times, I then created ports for each camera on my router and still can't connect to icamsource.

The messages I receive are; UPnP May Not Be Enabled (I can't find any settings on the router for this) and "your network IP camera cannot be connected to".....

Any thoughts?

thanks

Pages: [1]