Messages

1

iCam Support / Re: Hauppauge 1150 no video

« on: January 09, 2012, 12:43:06 PM »

No problem.  I have exchanged the 1150 tuner card for a new Hauppauge 1600 and everything is working fine again.

2

iCam Support / Re: UDP Connection Error

« on: January 09, 2012, 09:54:56 AM »

Mine is back up now and working again....

3

iCam Support / Re: UDP Connection Error

« on: January 09, 2012, 08:37:57 AM »

Same here.  I also started a post about it...

4

iCam Support / Why Broker connection error today?

« on: January 09, 2012, 07:48:15 AM »

Home wifi Broker connection error, on 3G same error and now on work Wifi the same.  What's happening?

5

iCam Support / Hauppauge 1150 no video

« on: January 05, 2012, 05:10:05 PM »

I had an older hauppauge that worked fine but was starting to go bad.  Lines started forming on the screen so I bought a newer 1150, but now I can't get any video to show up in the  icam preference screen, nor on the icam software.
Any ideas? Windows xp.

6

iCam Support / Re: Possible AT&T 3G Changes Coming for iOS Devices Running iCam?

« on: October 26, 2011, 05:36:30 PM »

Yes everything is working great again...Thanks for your help.

7

iCam Support / Re: Possible AT&T 3G Changes Coming for iOS Devices Running iCam?

« on: October 24, 2011, 04:16:31 PM »

Got the router port forwarding set up and now can connect with my firewall off.  Thanks.

Need to figure out the zonealarm firewall next, because I can't connect when it's running.



Edit....Have the firewall setup and all is working again.

Thanks for the help.!!!

8

iCam Support / Re: Possible AT&T 3G Changes Coming for iOS Devices Running iCam?

« on: October 24, 2011, 02:58:42 PM »

Linksys e2000 running zonealarm

9

iCam Support / Re: Possible AT&T 3G Changes Coming for iOS Devices Running iCam?

« on: October 22, 2011, 01:25:28 PM »

As a side note.  I had purchased another cam program from the app store a long time ago before I found iCam.  As a trial and error, I installed that program and can report I have no issues connecting.   I am able to connect with 3g or wifi seamlessly.  However I much more prefer the UI in iCam, so I would like to find a fix.  I have been using iCam for a long time with zero issues.

Why, if this is a possible IP problem would it not affect the other apps?

10

iCam Support / Re: Possible AT&T 3G Changes Coming for iOS Devices Running iCam?

« on: October 21, 2011, 09:50:59 PM »

Yeah, I always run auto config. I haven't changed anything.  The message says upnp success 12001 -> 12001.

11

iCam Support / Re: Possible AT&T 3G Changes Coming for iOS Devices Running iCam?

« on: October 21, 2011, 06:44:26 AM »

This has been happening to me as well on 3g.
I'm normally connected to wifi somewhere but recently tried to connect over 3g and received the cannot connect to sources. I have cameras at two separate locations.
198 ip in Lancaster PA.