Messages

1

iCam Support / Re: Troubleshooting 103 - Port Forwarding

« on: September 10, 2011, 12:44:36 PM »

I have already followed this instructions, but the screen shot examples that are given do not match what I have.  For instance, take a look at the screen capture below.

Here is a link to the port forwarding instructions for your particular router: http://portforward.com/english/routers/port_forwarding/Westell/A90-327W15-06/default.htm


Following these instructions:

Forward the port range 12000-12100 (UDP protocol)  to the computer running the iCamSource.

Once this is done and you've enabled port forwarding in the iCamSource program, you should be able to access your iCamSource.

To enable port forwarding in the iCamSource program, follow the directions in this forum post: http://skjm.com/forum/index.php?topic=402

2

iCam Support / Re: Troubleshooting 103 - Port Forwarding

« on: September 08, 2011, 10:41:14 AM »

It's a Verizon/Fairpoint Westell 327W DSL Modem

Thanks

What is the Brand/Model of your router?

3

iCam Support / Re: Troubleshooting 103 - Port Forwarding

« on: September 06, 2011, 06:10:32 PM »

I am using your trouble shooting tip post you provided to fix the source not found problem when you switch to 3G, and I get all the way to the point where you configure your router, but it does not look like the example given on the port forwarding site, I actually had to go into advanced settings and it said "     
   
Configuration File

    Use the Router's Configuration File feature to save and load configuration files, which are used to backup and restore the Router's current configuration.

     
1. To take Back up of the Router's current configuration, click the "Save Configuration File" button.
 
 
2.To Load a previously backed up configuration file, click the "Load Configuration File" button.
Note: Loading a previously backed up configuration file will overwrite the current configuration of the router.

Not sure which one to do, I do not want to mess up my router!  Thanks for the help.

4

iCam Support / Re: I cannot find iCam on my iMac after you close it?

« on: September 05, 2011, 11:35:38 AM »

Nevermind, its up in the top right hand corner as an icon

5

iCam Support / I cannot find iCam on my iMac after you close it?

« on: September 05, 2011, 10:42:37 AM »

Just downloaded iCam on my iPhone and iMac, and was playing around with it (Works great), but I closed it on on my iMac, and I can not find it to open it again?