Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - davidwaynea0

Pages: [1]
1
iCam Support / Re: Problems with multiple cams
« on: March 05, 2011, 08:24:15 AM »
Just tick the bottom left corner on the preferences of icamsource. "Auto config router"
reboot both computer and phone. it should work perfectly after that.

2
iCam Support / Re: "Cannot Connect To iCam Broker Server" on EDGE or 3G - Fix coming in iCam 1.0.2
« on: March 05, 2011, 08:23:48 AM »
Just tick the bottom left corner on the preferences of icamsource. "Auto config router"
reboot both computer and phone. it should work perfectly after that.

3
iCam Support / Re: Troubleshooting 102 - Source Connection Error
« on: March 05, 2011, 08:23:19 AM »
Just tick the bottom left corner on the preferences of icamsource. "Auto config router"
reboot both computer and phone. it should work perfectly after that.

4
iCam Support / Re: Troubleshooting 101 - iCam & iCamSource Error Messages
« on: March 05, 2011, 08:22:20 AM »
Hey guys if your icam and icamsource dont connect with each other just stop the video feed, and go to the bottom left corner of the preferences and select "Auto config router". reboot your computer and phone and it should work perfectly. both on WIFI and 3G.

5
iCam Support / Re: "Cannot Connect To iCam Broker Server" on EDGE or 3G - Fix coming in iCam 1.0.2
« on: March 05, 2011, 08:20:59 AM »
Guys for the people who cant seem to connect to the cameras using their iphones over 3g, go to your computer and open the icamsource preferences. after you see the panel open up go to the bottom left corner and tick the "Auto-Config Router". start up the video again. and it should work fine. If it doesn't, leave it checked, and reboot your computer and phone, and try again. hope it helps.

Pages: [1]