Messages

1

iCam Support / Re: icam.exe - entry point not found

« on: March 02, 2011, 02:32:22 PM »

thanks OuAnthony , just run that file it ask if i wanted it repaired i said yes but still getting same message each time icam source opens and i click the start button.

Hi Stefan , no never had any problem when i first installed icamsource, i have been using it a while now from a £9.99 webcam although it used to freeze after about 12 hours so i bought from Misco a pro 9000 for business about a week ago installed the drivers from there website as it never came with CD and thats when all my problems begun belive it or not, but dont get me wrong the cam is great on it own software however i have now tried going back to my cheap cam but thats giving me same message so im really confused lol , yes all driver on xp up to date as are logitech , cam is plugged direct into computer, but as i said earlier if i rapidly click the error message im getting it will work sometimes for a min or so but today its been working for around 8 hours before it stopped , now im getting same message again, HELPPPPPPPPPPPPPPPPPPPPPP lol

2

iCam Support / Re: icam.exe - entry point not found

« on: March 01, 2011, 05:44:51 PM »

hi

Yes i have been on to windows updater and no new updates available

i was getting the message as soon as i clicked on the icon but now if i click the icon it dosent even open at all, i just deleted icamsource and then downloaded again but still when i click it ,it wont even open.
yet the logitech cam is working perfect with its own software ie zooms , motion detects , just not with icamsource 

sry not that good with computers but now it letting me open icamsource from tray but now getting message error code 14 render stream failed
 lol i shut it all down and its now gone back to the first message , laugh or cry lol

3

iCam Support / icam.exe - entry point not found

« on: March 01, 2011, 12:01:44 PM »

Hi

Need some help please, i keep getting the message as above + the procedure point _mbsnbcpy_s could not be located in the dynamic link library msvcrt.dll.
now if i click it rapidly it will work for a few mins the i get icam needs to close.
I'm using Logitech webcam pro 9000 for business on windows xp.
I have tried by deleting icam source cleaning registry reloading etc but still get same message , even went back to logitech site and made sure got right software.

well any advise would be greeeeeeeeeeeeeeeeeeeat please guys

Kind Regards