Messages

1

iCam Support / iCamSource runs only once - Windows 7 64 bit

« on: February 06, 2011, 01:08:10 PM »

I'm having the same problem running Windows 7 64 bit. I can run iCamSource one time, but then when I try to run it again, nothing happens. The program won't open, but there is no error message. I have to reboot my computer to get it to run again. I'm using a single camera which is integrated into my Dell laptop.

Based on information located in this forum, have tried the following without success:

• Ran registry cleaner downloaded here
• Disabled audio
• Uninstalled then reinstalled iCamSource
• Last Windows update was 02/02/11 but same behavior occurred before and after

Any suggestions to help me get this working properly?