Messages

1

iCam Support / Re: Supported Pan-Tilt USB Webcams and Network IP Cameras

« on: November 10, 2011, 02:11:41 PM »

I was maybe a little unclear:

In iCamsource it says:QuickCam Orbit/Sphere AF (just as your setup)
In the "Logitech webcam controller"-window it is stated: "is used by: iCamSource", which should be ok

I can control the cam from the pc, but not in the androidphone

It seemed like PTZ was working from reading the top of this thread (iPhone+ Android version)

Any ETA for PTZ on Android?
(Otherwise keep up the good work with improving iCam (for both phone versions)

2

iCam Support / Re: Supported Pan-Tilt USB Webcams and Network IP Cameras

« on: November 10, 2011, 11:29:38 AM »

Hi

I also have a Logitech Orbit AF, WIN7 64bit

ICam source works fine (2.4,2.41,2.42)

I have tried
http://skjm.com/icam/CleaniCamKey.reg

Orbit is connected direct into the PC.

You can see that "Logitech webcam controller" is used by iCamSource, BUT that just it

You can not remote control the Orbit from ICam in the Android phone

Please advice

3

iCam Support / Re: Re: CPU load very high when using ICamSource

« on: January 14, 2011, 06:02:04 PM »

Keep up the good work, Icam is a very good app and hopefully next releases have improved performance :-)

4

iCam Support / Re: Re: CPU load very high when using ICamSource

« on: January 13, 2011, 01:59:36 PM »

I use 2 usb cameras. When only using one, the cpu load goes down to 40 %.

Still quite high though, hopefully high load on cpu will be targeted i next sw-releases

BR

5

iCam Support / Re: Re: CPU load very high when using ICamSource

« on: January 12, 2011, 01:04:10 PM »

My exact specs are Atom 330 ION pc,4GB ram,Win 7 and SSD which has enough power for 1080p.I know the cpu is "weak" but iCam is the only application that gives such high CPU load (except Crysis ofcourse ;-)

6

iCam Support / Re: CPU load very high when using ICamSource

« on: January 12, 2011, 08:37:59 AM »

Thanks for the reply but...

The motion detection is disabled (I dont use it)

I have also tried to update .Net but still high CPU-load when using Icam source

7

iCam Support / CPU load very high when using ICamSource

« on: January 10, 2011, 01:09:54 PM »

Hi

I use IcamSource 2.2.1 on a AtomPC(cpu 330) with win7. The pc handles most sw and loads of serverprograms can run in parallell without problems.

But when starting IcamSource the CPU- load increases to 50-60%

Is there any way to decrease this since it makes the pc slow?
Hopefully updates of the iCamSource sw will target this problem

/Br