SKJM Forum

Support => iCam Support => Topic started by: bricekar on July 06, 2014, 07:03:57 AM

Title: Heden icam issue
Post by: bricekar on July 06, 2014, 07:03:57 AM

dear, thanks for any help.

i'm configuring on the icam the heden webcam ip, but the webcam is secured with login/password.
how could we configure the parameters for accessing the webcam ?

i had information from this website :http : // www [dot] ispyconnect [dot] com / man.aspx? n = Heden

i tried :
http : // IPADDRESS / videostream .cgi ? user = [USERNAME] & pwd = [PASSWORD]
or
http : // IPADDRESS / video.cgi ? user = [USERNAME] & pwd = [PASSWORD]

could you please help ?

thx

Title: Re: Heden icam issue
Post by: SKJM Support on July 07, 2014, 02:32:42 PM

We haven’t tested with that particular camera, but if it outputs MJPEG formatted data, it’ll probably work with iCamSource.

When you run iCamSource, you’ll need to select the "Ethernet /Wi-Fi" tab because the camera is a network camera, not a USB camera. Then, enter the MJPEG or JPEG URL for your camera.

If the MJPEG or JPEG URL isn’t something that can be found by searching around with Google or by contacting their support, we actually have another solution available, although it is currently in its very preliminary stages, and that is: http://skjm.com/icam/mjpeg_test.php (http://skjm.com/icam/mjpeg_test.php)

When you enter the camera’s IP address and port into that web page, it will attempt to connect to the camera using all of the common MJPEG and JPEG URLs that we are aware of. If any of the URLs produce an image, then that is the URL to use in iCamSource.

If your camera requires a login and password, you can enter them in that webpage right before the address: login:password@Camera_address

Title: Re: Heden icam issue
Post by: bricekar on July 07, 2014, 04:19:45 PM

i've tried on your weblink to the which url is working.

the issue i get is that to test all known tries, login and password are asked

i've tested on your webpage, the url link fomatted like this, which was working
http://login:password@192.168.0.207:80/video.cgi

That working formated urllink is not working on  the UMS multiclient.V2.1.0.1
i'm also obliged to feed information (port and password), if not, issue message displayed !
please help

Title: Re: Heden icam issue
Post by: SKJM Support on July 09, 2014, 01:45:56 PM

Please email a screenshot of iCamSource after you click the Start button to support@skjm.com, so we can verify the settings. Please reference this forum post and your user name in your email.