SKJM Forum

Support => iCam Support => Network / IP Camera Compatibility => Topic started by: jscalo on April 14, 2012, 02:33:46 PM

Title: Agasio A622W
Post by: jscalo on April 14, 2012, 02:33:46 PM

This is an outdoor wireless pan/tilt with IR-cutoff and at $200 from Amazon it seems to be a pretty good deal, if I could only control it with iCam :-)

I'm able to get a MJPEG feed from the camera (the path is /videostream.cgi in case anyone else is trying to get this working), but tilt/pan doesn't work at all. Any hope of getting this support in iCam? Using an http tracer I can see that the commands are:

/decoder_control.cgi?command=4 -- left
/decoder_control.cgi?command=6 -- right
/decoder_control.cgi?command=2 -- up
/decoder_control.cgi?command=0 -- down
/decoder_control.cgi?command=1 -- stop

It's sold by Foscam so maybe it's just a rebranded Foscam model… ?

Thanks

Title: Re: Agasio A622W
Post by: Stefan on April 16, 2012, 08:49:31 AM

The iCamSource attempts to implement the Foscam PTZ commands when the MJPEG URL is video.cgi instead of videostream.cgi ... Does video.cgi work with that camera?

Those PTZ commands do look to be the same as the Foscam ones, so perhaps just using video.cgi will work for you.

Title: Re: Agasio A622W
Post by: jscalo on April 16, 2012, 09:13:56 AM

Ah, video.cgi does indeed work. Thanks!