SKJM Forum
Support => iCam Support => Topic started by: theblarney on March 15, 2011, 04:09:21 PM
-
Hi,
I am new to this forum so please bear with me.
I am using Icamsource with a Cisco 877 so using the auto configuration wasnt an option for me.
I have managed to open up all the ports needed to allow icamsource and icam to connect to each other but to get it to work I had to allow any UDP traffic from the internet to the server running icamsource.
Is there anyway I can lock this down a little?
I have found the ip address of the broker server but I do not see how this would help as I think (correct if I am wrong) Icam talks directly to icamsource?
I have limited the ports as suggested to 12000 to 12100.
Thanks
Gavin
-
iCam and the iCamSource do communicate with the iCam Broker Server on UDP port 12613 when setting up the peer-to-peer connection, so possibly opening that port as well will allow you to connect.