SKJM Forum

Support => iCam Pro Support => : threat45 March 14, 2015, 12:21:28 PM

: Will the iCamPro FHD be supported?
: threat45 March 14, 2015, 12:21:28 PM

Just went on the wait list for them to be shipped in June, will iCam Pro support this at launch?

A

: Re: Will the iCamPro FHD be supported?
: SKJM Support March 17, 2015, 01:57:16 PM

We haven’t tested with that particular camera, but if it outputs MJPEG formatted data, it’ll probably work with iCamSource.

When you run iCamSource, you’ll need to select the "Ethernet /Wi-Fi" tab because the camera is a network camera, not a USB camera. Then, enter the MJPEG or JPEG URL for your camera.

If the MJPEG or JPEG URL isn’t something that can be found by searching around with Google or by contacting their support, we actually have another solution available, although it is currently in its very preliminary stages, and that is: http://skjm.com/icam/mjpeg_test.php

When you enter the camera’s IP address and port into that web page, it will attempt to connect to the camera using all of the common MJPEG and JPEG URLs that we are aware of. If any of the URLs produce an image, then that is the URL to use in iCamSource.

If your camera requires a login and password, you can enter them in that webpage right before the address : login:password@Camera_address

: Re: Will the iCamPro FHD be supported?
: threat45 April 04, 2015, 04:44:00 PM

Thank you for the information! I will be sure to test this and report back in a couple months.

A