Messages

1

iCam Support / Re: Just got my Airlink101 cam today... Mac user help needed !!!

« on: May 31, 2012, 12:46:51 PM »

I have the same setup as above (all Mac) and an airlink 1500w camera. The webcam works fine, and is visible on my iphone. The Airlink cam works fine wired, (though the iphone won't see it for some reason) but I don't know how to set up the wireless feature to operate. Do I need to give my wifi password to the camera? How do I do that with ipcamconfig? I don't use Windows. Do I access the camera via safari browser? The instructions in ipcamconfig stop after the camera is reconfigured, but don't go the next step in getting the wireless feature to work....

2

IP Cam Config Support / Re: airlink101w

« on: May 30, 2012, 09:33:23 PM »

I have the same problem as above, and the directions don't help with the last step: going wifi.

I have been using icam and icamsource using my macbook's camera and iphone without difficulty, and wished to get a wifi camera. I selected the airlink 1500W camera and have connected/configured it with the ip cam config app to the icamsource via the network cable into my airport extreme wireless router.

How do I make the next step and go wireless with this camera? When I disconnect it from the network cable, the connection is lost.

Additionally, my iphone will not display the airlink images, even when the airlink camera is hardwired to the router. Instead it will only display webcam images. This occurs with 3G and with wifi. This second problem is obviously a question for a different forum, but I did not seen where it should go.

I have checked my firewall and it permits the icam software to make connections.