SKJM Forum
Support => iCam Support => Topic started by: Mzwei on December 14, 2015, 11:48:35 AM
-
Hi!
In earlier versions of iCamsource it was possible to add two fields to define the port forwarding range via the terminal with this command:
defaults write com.skjm.icamsource PortRangeSet -bool true
If I try that with 2.8.4 on El Capitain there are no fields added to define the port range. :(
How can I enable the two fields to define the port range?
Thanks!
-
I'm also looking for a solution to this!! I used the command and nothing changed with El Capitan.. :(
-
Same problem in Sierra. Did you ever get an answer to this?