SKJM Forum
Support => iCam Support => : bob1966tb June 22, 2010, 04:17:00 AM
-
Hi,
I just purchased your program and am trying to view my camera using iCamSource.
My Camera is an Asante Voyager I running 2.02 firmware. It can stream MJEP.
I am using the following URL:
http://ip.ip.ip.ip/image.jpg?type=motion
I found that URL from the following forum:
http://www.crazypixels.com/forum/viewtopic.php?f=3&p=1002
Anyway -- no dice. I get an error from iCamSource
" your network camera can not be connect to "
Any ideas of what to try next ?
BTW - the Asante works from my LAN and can also be viewed from the WAN by using IE or Firefox.
Thanks for any suggestions !
Best Regards,
Bob
-
Hi,
I just tried the Live Cams iPhone app and it seems to work fine.
I am able to view my Asante Voyager on my iPhone with this app.
I purchased your Icam/Icamsource app yesterday and would like to use it also -- for the motion detection feature.
I look forward to your feedback regarding your app on this Asante camera.
Best Regards,
Bob
-
Are you using the internal IP address of the camera, and is your camera listening on a port other than the default, 80?
The MJPEG URL that we have in our database (http://skjm.com/icam/mjpeg.php) is: http://xxx.xxx.xxx.xxx/image.cgi
Where xxx.xxx.xxx.xxx is your camera's internal IP address.
If you are using a custom port, the URL would be http://xxx.xxx.xxx.xxx:yyyy/image.cgi
Where yyyy is the port.
What is the URL that you use to connect to the camera in your web browser from your computer?
-
Hi,
Yeppers -- "another" Port issue ;)
This is what I used based on your suggestion and the fact that I am using a re-directed ( NON Port 80 ) setup
http://ip.ip.ip.ip:PORT/image.jpg?type=motion
And.........
It works !!
Ain't Science wonderful
Thanks for your FAST feedback.
Best Regards,
Bob
-
You are most welcome! ;D